FWP2

SafeAir1 & Avery Tools... A partnership, bringing you the best in creative solutions for Experimental Aviation

Announcing...
SafeAir1 Firewall Pass-Thru System !!

A SAFER alternative for passing electrical wires and tubing through the firewall.

The SafeAir1 Firewall Pass-Thru System could easily be one of the best investments you ever make for your airplane. Inflight fire can kill... And post-crash fire destroys hundreds of airplanes every year - even airplanes that were not substantially damaged in a moderate crash.

Firewall Pass-Thru acts in FOUR very important ways:

REDUCES the chance of fire ignited by electrical current due to crash damage.
REDUCES the chance of inflight chaffing of wires that cross the firewall - Which can START a fire or disable the charging system along with a number of other possible symptoms.
SLOWS DOWN PENETRATION of an inflight engine compartment fire - Increasing the pilot's time to get the airplane safely on the ground.
SEALS FIREWALL penetration points for wiring and cabling - reducing the chance for CO (carbon monoxide) to pass into the passenger compartment.

Back to
Firewall Pass-Thru
Introduction

Installation
Technical Details
CLICK HERE

Why choose the SafeAir1
Firewall Pass-Thru?

Firewall Pass-Thru
is properly designed for the job:

Pass-Thru Fitting is installed from aft to fore in the firewall - providing a smoothly radiused exit for wires and cables.
Stainless steel construction resists heat and fire - this is the same material that your firewall is made from.
Backing Ring helps to block heat and seal out dangerous gases.

Buy this product now

Compare the Firewall Pass-Thru with other methods for protecting your airplane.

Feature or Concern	SafeAir1 Firewall Pass-Thru	Other Methods	Notes
Stainless steel components?	Yes	Yes
High temp, fire resistant materials?	Yes	Yes
Allows adding/removing wires in the future?	Yes - The FPT does not require adhesives or silicone	Maybe*	Any use of silicone or adhesives may make adding/removing wires very difficult.
One piece, NO weld design?	Yes*	No	Less potential for cracking, corrosion, and NO sharp edges.
Design evenly distributes loads?	Yes*	No.. design introduces stresses into firewall	FPT features Backing Ring, providing 360 degree load distribution on BOTH sides of firewall.
Design minimizes potential firewall cracking?	Yes*	No.. see above	FPT designed with circular base.
Design limits absorption of fluids?	Yes*	No	SafeAir1 "end dips" all FPT "Pyro" materials.
Anti-chafe design for cabling?	Yes*	Yes	FPT one piece, spun design with gentle radius protects cables.
Safe for builders and ongoing maintenance?	Yes*	No - too many sharp edges	No sharp cutting edges exposed.
Complete stainless hardware kit included?	Yes*	No	Other methods leave it to you to find the right hardware.
Kit designed for future airplane requirements?	Yes*	No - silicone or epoxy fillers must be removed	Spare FPT can easily be installed and sealed during construction.
Quality Installation Guide included?	Yes*	??	Simple, two page, color Guide with digital photos.
Best value?	$47 Each	$75 Each
Your satisfaction?	GUARANTEED !!		All SafeAir1 products are backed by our full satisfaction guarantee.